910H shaft length problem

Follow Thread

By Warren B

  • 0 Likes
  • 3 Replies
  1. Warren B

    Warren B

    Hi,

    I recently ordered a replacement shaft (V2 104x) for my 21* 910H from a titleist custom fitting retailer in the UK. Once the shaft arrived I didnt measure it but went out to try it out. However, after addressing the ball it felt awkward and a bit long.

    When I got home I put the tape measure to it and I believe it has come 1" too long.

    The length of the shaft before being installed to the club is 40" (measured from butt to tip including the sft hosel).

    Before being attached to the club my driver is 44" my 3 wood is 42.25" and my 24* hybrid is 38.5"

    Can someone confirm if this has come 1" too long?

  2. Lou G

    Lou G
    San Diego, CA

    I would think a 21H would be 1/2" longer than a 24. You would probably have the same measurements as I do (I am 6'1" with WTF of 35.5) - my driver is 45, 3 wood is 42.5, 7 wood is 41.5 and 5H is 38.5.
  3. albert w

    albert w
    san jose, CA

    Hi Warren,

    I had the same problem with 910D3.  Cathi from Titleist told me to take it to the nearest authorized dealer and send in for warranty repair.  See below for the response.

    http://www.titleist.com/teamtitleist/team-titleist/f/6/p/9786/44106.aspx#44106

  4. Joe B

    Joe B
    Philadelphia, PA

    Standard finished length installed in the 910H is 40" for a 21*.

Please login to post a comment.

Sign In

Haven't registered for Team Titleist yet?

Sign Up

Find a golf store near me