Hard stepping the shafts

Follow Thread

By james s

  • 0 Likes
  • 2 Replies
  1. 0 Posts

    Just got fitted for a set of ap3's. The set was ordered to have -1/2" 2 degrees upright with and r300 black shafts hard stepped. First question is if the shafts are hard stepped my 7 will have an 8 shaft but will it be cut to the standard 7 iron length, then minus the half inch? Second question is my swing speed with the 7 iron was between 78 and 85mph. Until today ive never heard of stepping shafts. Does this sound like the right choice for my swing speed?

  2. 19hole
    Woburn, MA

    0 Posts

    If you were properly fitted by a certified Titleist fitter, you should trust that he/she knows what they are doing. It is not really possible to tell you what shaft to use based on swing speed alone, there are just too many other factors involved.

    A "hard" or "soft" stepping is done to a shaft to change the flex slightly. It is usually used when you are in between shaft flexes. It is also called "tipping" by some people.
  3. 0 Posts

    Hi James, Yes, we will use an 8 iron shaft to build your 7 iron and will butt cut it to the 7 iron length (minus 1/2"). We would assume that your fitter had you hit both the R flex as well as the S flex and determined that an in between flex would be most optimal for launch and spin. The hard stepping of an R flex will make it play slightly firmer than the R, but not as firm as the S flex.
    As far as speed, yes, this would be in the ball park, but each individual loads the shaft slightly differently and your fitter can show you why it is the best choice for you. We would recommend that you ask your fitter these questions as he could explain his reasoning for the selection of shaft as well as the hard stepping.

Please login to post a comment.

Sign In

Haven't registered for Team Titleist yet?

Sign Up