Shaft extension

Follow Thread

By Michael B

  • 0 Likes
  • 7 Replies
  1. 0 Posts

    I have just purchased AP1 718 irons. They are standard length with amt regular steel shafts. I previously was fitted for and played png white dot plus .5 inch in length. I am 6’2” and my wrist to floor is 37”. Appreciate any recommendation. V/R Michael Borchers

  2. 0 Posts

    It's impossible to say Michael. You would have to see a qualified fitter who would recommend you on your swing through a launch monitor and ball flight.
  3. PrecisionMobileGolf
    Nashville, TN

    0 Posts

    If you are simply going off what png recommended for you, then extend the irons 1/2 inch and bend the 7 iron to 65° and use that iron as the guide to bend the other irons. If you don't have someone you trust to do this, you can contact me at jason@precisionmobilegolf.com and I can do that work for you.

    I hope this helps
  4. Joseph M
    Saint John, New Brunswick

    0 Posts

    The biggest issue could be lie- the pings at green would be two degrees more upright than Titleist- the additional length makes the playing lie upright by another degree. That's the technical side, however, if you are not having issues with center contact and/or you are taking normal divots (e.g. the toe isn't digging causing misdirection) I wouldn't worry. If you were fitted these potential issues were probably taken into consideration.
  5. Joseph M
    Saint John, New Brunswick

    0 Posts

    Sorry, said green color code in error- my comments were to apply to white code not green- adjustments to match png are as stated by PrecisionMobileGolf above.
  6. Don O
    Madison, WI

    0 Posts

    Just to add some more confusion, Titleist irons are/used to be 1/4 inch longer than the standard png irons. I didn't think it made much of a difference, but at my first fitting it took a + 1/4 inch png shaft to make the same contact as the standard Titleist.
  7. David
    Erie

    0 Posts

    everyone's a little different so getting fit is a good idea but i'm 6'2 and i play the 718 ap1's a half inch longer so you might as well. I would definitely check the lie and adjust it depending on how youre delivering the clubhead at impact, even though were the same height/build we may need different lie angles to hit it straight. good luck with the ap1's, theyve been great for me!
  8. Joseph M
    Saint John, New Brunswick

    0 Posts

    To clarify the standard length between Titleist and png, standard lengths have been the same as Titleist since the introduction of their G30 iron

Please login to post a comment.

Sign In

Haven't registered for Team Titleist yet?

Sign Up